GroutPro Glass Protector is a Nano-Coating which creates a highly effective invisible barrier that lasts up to 5 years. It prevents water spots, stains and other residue from bonding to glass, windows, glass showers and other hard surfaces. GroutPro Glass Protector contains special inhibitors to prevent mould and bacteria.
Use GroutPro Glass Restore to remove existing stains and build up, final clean with GroutPro ProGleam or alcohol based clean then dry thoroughly. Spray directly onto about 1 square metre of glass and using a clean dry micro fibre cloth, apply sparingly by wiping over the surface in a circular motion until dry which may be up to 1 minute.
Once dry, move onto the next section of glass until complete. Wait 5-10 minutes, then with a damp cloth, polish the glass to remove any visible swirls of residue. Finally wipe with a dry cloth until all residue is removed. The coating can be removed with an alcohol based cleaner and reapplied if the first application is not done correctly and swirls are still visible. Ensure surface is clean and dry. Spray directly onto surface or onto a clean dry micro fibre cloth and apply sparingly by wiping over the surface in a circular motion. Allow to dry and repeat for a second coat.
Re-apply GroutPro Glass Protector after regular cleaning of protected surface to maintain protection. After 3 – 6 months use GroutPro Glass Restore to eliminate any build up or contamination and re-apply.
The Nano—Coating will last up to 5 years so there’s no need to maintain the coating except periodic minor cleaning. Using a squeegee to blade off or drying the glass with a micro fibre cloth after use will extend the performance capabilities of GroutPro Glass Protector.
Regular maintenance cleaning with GroutPro ProGleam can extend the protection offered by GroutPro Glass Protector. Reapply after 5 years or when needed.
Always test first according to directions to determine desired results.
Store product in a well ventilated area away from direct sunlight. Store below 50 c
Inhalation: If irritation occurs, contact a Poisons Information Centre, or call a doctor. Remove source of contamination or move victim to fresh air. If breathing is difﬁcult. oxygen may be beneficial if administered by trained personnel, preferably on a doctor’s advice. In severe cases. symptoms of pulmonary oedema can be delayed up to 48 hours after exposure.
Skin Contact: Wash gently and thoroughly with warm water (use non-abrasive soap if necessary) for 10-20 minutes or until product is removed. Under running water, remove contaminated clothing, shoes and leather goods (eg. watchbands and belts) and completely decontaminate them before reuse or discard. If irritation persists, repeat flushing and seek medical attention.
Eye Contact: Immediately flush the contaminated eye(s) with lukewarm, gently flowing water for 15 minutes or until the product is removed, while holding the eyelid(s) open. Take care not to rinse contaminated water into the unaffected eye or onto the face. Obtain medical attention immediately. Take special care if exposed person is wearing Contact lenses.
Ingestion: If swallowed, do NOT induce vomiting. Wash mouth with water and contact a Poisons Information Centre, or call a doctor.
Do not use on acrylic, fibreglass, seretone or other moulded or coated shower linings or surfaces. Do not apply to the inside of any vehicle, building or boat glass. May react with some metals.
Keep away from open ﬂames. no not smoke when using. Use in well ventilated area. Always use PPE when applying this product.